WKidea finishes its wooden products with natural beeswax only, with no paint or lacquer. Before waxing, the wood goes through several rounds of alcohol and sanding. This article explains what each step does, and why phone cases get more rounds.
Key points
- Process: spray alcohol → sand → wax by hand.
- Sandpaper from coarse to fine: 240 → 400 → 600 grit.
- Items carried close every day get three rounds; items handled less get two.
- The only surface finish is natural beeswax.
Why spray alcohol before sanding?
Sanding presses wood fibers flat. The surface feels smooth, but the fibers are only lying down, not removed. With humidity or sweat from the hand, they stand up again and the surface turns rough.
Spraying alcohol makes the flattened fibers stand up ahead of time, so the next round of sanding can actually remove them and sand more evenly. Alcohol evaporates quickly and does not make wood swell the way water does. Its job is more than clearing dust.
Why change grit one step at a time?
The higher the grit number, the finer the abrasive. Coarse paper removes tool marks and levels the surface but leaves its own scratches; the next finer paper removes those. Skip a step and the coarse scratches stay, showing up even more after waxing.
| Round | Grit | Purpose |
|---|---|---|
| Round 1 | 240 → 400 | Remove CNC tool marks and level the surface |
| Round 2 | 400 → 600 | Remove scratches from the previous round and the raised fibers |
| Round 3 | 600 grit fine finishing | Refine edges and curves that the hand touches directly |
What does the beeswax do?
Beeswax fills the fine pores at the surface and forms a thin protective layer, so the wood picks up less dirt and moisture while keeping the feel of the grain. We wax while the pores are still open after sanding, then wipe off the excess with a cloth.
Unlike a lacquer film, beeswax does not seal the wood off, so you can re-wax it yourself later.
Why do phone cases get three rounds?
Phone cases and earbud cases go in and out of pockets and sit in the hand every day, meeting far more sweat and friction than objects that stay on a desk. One more round of alcohol and sanding clears the raised fibers more thoroughly, so the surface holds up over long use.
How do I care for it at home?
- For everyday care, simply wipe it with a dry cloth.
- Now and then, apply a thin coat of natural beeswax, then wipe off the excess with a dry cloth.
- Avoid soaking it in water or leaving it in direct sunlight for long periods.
Written by Willy Kang, founder of WKidea. There is no secret formula in how WKidea works, only repetition: nothing special, just practiced hands.